Acer Chromebook C732 - Replacing the USB Board (for C732 & C732 T Only)

3-62 Machine Maintenance Procedures
Replacing the USB Board (For C732 & C732T only) 0
1. Place the USB board onto its compartment on the top assembly. Make sure that the
two apertures on the USB board are aligned with the studs (A) located on the top
assembly (Figure 3-79).
Figure 3-79. Replacing the USB Board
2. Install and secure one (1) screw (B) to the USB board (Figure 3-80).
3. Connect the DBL end of the USB board high-speed FPC (D) to the USB board
connector (C) and connect the MBL end to the mainboard connector (E) (Figure 3-80).
4. Connect the DBL end of the USB board low-speed FPC (G) to the USB board connector
(F) and connect the MBL end to the mainboard connector (H) (Figure 3-80).
Figure 3-80. Replacing the USB Board
A
D
E
B
G
H
C
F
DBL
DBL
MBL
MBL