Machine Maintenance Procedures 3-49
Replacing the eDP and Camera Cable 0
1. Place and secure the eDP and camera cable to the cable guides on the left side of the
LCD cover (Figure 3-62).
Figure 3-62. Replacing the eDP and Camera Cable
2. Connect the microphone cable (D) to the microphone connector and adhere the tape
(C) to secure the microphone cable to the microphone board (A) (Figure 3-63).
3. Connect the camera cable (D) to the camera connector (B) (Figure 3-63).
Use care not to damage the cable.
Figure 3-63. Replacing the eDP and Camera Cable
Make sure the eDP and camera cable is secured currently along the guides to
avoid damage when replacing the LCD hinges.
To Next Page
Loading...
