2-10 System Utilities
5. The system will clean the data and switch to Developer Mode. Wait 30 seconds, then
the system will proceed to the next step automatically.
Figure 2-14. Transitioning to Developer Mode Screen
6. A message will appear to indicate that the system is transitioning to Developer
Mode. A transition status will be displayed on the top portion of screen. This process
may take about 5 minutes. Once this process finishes the system will automatically
restart.
Figure 2-15. Preparing system for Developer Mode Screen
7. Press
Ctrl + D
to skip the waiting period and the system will automatically restart. Or
the system will automatically restart after 30 seconds and will beep twice at the
20-second mark.
8. Press the
power
key to turn off the system when the OS verification is OFF
message is displayed.
Figure 2-16. OS Verification Off Screen
To Next Page
Loading...
