System Utilities 2-31
Left USB Type-A Port Test 0
Any data in the inserted USB drive will be cleared during the USB test. Ensure
that you either use an empty USB drive or back up all the data located in the
drive before you proceed with the USB test.
1. Insert a USB 2.0 drive into the USB port on the left side of the system.
Figure 2-61. USB 2.0 Performance Test
2. Remove the USB 2.0 drive when the progress bar reaches 100%.
Figure 2-62. USB 2.0 Performance Test
3. Insert a USB 3.0 drive into the USB port on the left side of the system.
Figure 2-63. USB 3.0 Performance Test
To Next Page
Loading...
