Acer P1200 - Disassemble Keypad Board and Zoom Ring

P1100C/P1200i/P1200B
Condential
2-4
2-4 Disassemble Keypad
Board and Zoom Ring
1. Tear off the Maylar (as green square)
and unplug the FPC Cable.
2. Unscrew 4 screws (as red circle) to
disassemble the Keypad Board Module.
3. Separate the Keypad Board and Keypad
Module.
4. Unscrew 3 screws (as yellow circle) to
disassemble the Zoom Ring Module.
5. Loosen 2 tenons (as white square) to
separate the Zoom Ring Holder and the
Zoom Ring.
NOTE: Circuit boards > 10 cm² has been
highlighted with the yellow rectangle
as above image shows. Please
detach the Circuit boards and follow
local regulations for disposal.
Keypad Module
FPC Cable
Zoom Ring Zoom Ring Holder
Keypad Board