P1100C/P1200i/P1200B
Condential
3-3
No Symptom Procedure
4
No Image
- Ensure the Signal Cable and Source work
(If you connect multiple sources at the same time, use the "Source"
button switch)
- Ensure all connectors are securely connected and aren’t broken
- Check Main Board
- Check DMD Board
- Check DMD Chip
- Check Engine Module
- Check IO Board (Only when you use LAN, WLAN or USB B to proj-
ect)
- Check Wireless Card (Only when you use WLAN to project)
5
Mechanical
Noise
- Check Color Wheel
- Check Fan Module
6
Line Bar/Line
Defect
- Check if the Main Board and the DMD Board are
assembled properly
- Check Main Board
- Check DMD Board
- Check DMD Chip
7 Image Flicker
- Do "Reset (All data)" of the OSD Menu
- Ensure that the signal cables and source are work well
- Check Lamp Driver
- Check Waveform has been downloaded
- Check Lamp Module
- Check Color Wheel
- Check Photo Sensor
- Check DMD Board
- Check Main Board
To Next Page
Loading...
