7
tant gloves when removing prints from a build platform, just in
case your knife slips.
• Washer – A bath to remove the bulk of the residue may be cov-
ering the piece immediately when the print process is com-
plete.
• Cleaning alcohol – Most resins require either isopropyl alcohol
(99% solution) or ethyl alcohol (95% solution) for cleaning.
Please contact your resin distributor or refer to the related doc-
umentation for information about the proper cleaning alcohol
to use. You can also add the cleaning alcohol to a washer or
bath.
• Spray bottle for cleaning alcohol – Use the spray bottle to clean
the part, your equipment, or workspace.
• Alcohol wipes (Isopropyl alcohol 75%) – Another method for
cleaning your prints and workspace.
• Air blower or compressed air – Use the compressed air to
remove alcohol and to clean the part, your equipment, or work-
space.
• Rubber or silicone spatula – Use this to move or mix the resin in
the vat.
• Scraper or knife – A sharp blade is useful for removing the part
from the build platform. Dull scrapers can damage the build
platform.
• UV box – Ackuretta resins are all tested with the Ackuretta UV
oven. Other resin suppliers usually recommend different UV
boxes for curing.
• Rubber mallet – A mallet is useful for removing the part from
the build platform.
• Microfiber cloth – Cleaning the LCD print screen
To Next Page
Loading...
