15
Setting up Your Printer
3.1 Setup environment
This printer is designed and to be treated as commercial or indus-
trial equipment that is installed in locations where only adults are
normally present. It is not suitable for use in locations where chil-
dren are likely to be present.
Consider the following when choosing where to set up your
printer and your workspace.
3.1.1 Temperature: 18° - 25° C
Keep your printer and your resins in a dry, temperature-controlled
room around 22° C (72° F).
Resins become more viscous when they are too cold. If the envi-
ronment is around 15° C (59° F), Ackuretta recommends increasing
all curing times by 15%. Even colder temperatures may require
increasing curing times further or may cause print failures.
Similarly, resins may become very thin in hot temperatures. If the
environment is hotter than 35° C (95° F), resins may overcure or
may melt during the print process.
To Next Page
Loading...
