19
3.4 Attaching the vat
You must remove your vat whenever you change resins, replace
the vat film, or need to clean the vat.
To put the vat in place on the printer:
Step 1 If the vat lock frame is down, press the two tabs to
release it and lift it. A magnet holds the vat frame in
the raised position.
Step 2 Put the empty vat on the print screen and make sure
the feet on the bottom of the vat sit in the holes
around the print screen.
Step 3 Lower the vat lock frame over the vat and push it
down until the tabs click and lock it into place.
Result of this task: The vat is now attached to the printer and is
ready for adding resin.
3.5 Adding resin to the vat
To add resin to the vat:
Step 1 Select a specific resin for the application.
Step 2 Shake the bottle for approximately two minutes to
thoroughly mix the resin.
Step 3 Open the bottle.
Step 4 Pour the resin in the vat, starting at one side and
moving to the other so that the resin is evenly dis-
tributed across the bottom of the vat.
More info: There are level indicators on the vat to
show the volume of resin, i.e. 100 ml and 150 ml.
To Next Page
Loading...
