20
Step 5 Close the bottle immediately and put it in a safe
place for storage.
3.6 Attaching the build platform
The build platform is attached to the printer during shipping but
you must remove the build platform whenever you remove the vat.
To put the build platform back in place on the printer:
Step 1 Turn the knob on the build platform counterclock-
wise so that there is more space between the knob
and the build platform.
Step 2 Slide the build platform into the gap on the guide-
way arm. Make sure it is pushed back and doesn’t
twist.
Step 3 Turn the knob clockwise to securely attach the build
platform to the guideway arm.
Result of this task: Your printer is ready for use when the build
platform is in place and securely attached to the guideway arm.
To Next Page
Loading...
