16
3.1.2 UV-filtered lighting
The hood on the SOL protects the resin from ambient lighting
while it is closed. As you use the printer, the door will be opened
many times, and the resin will be exposed to UV light.
To protect the resin, set up the printer in a place where the lighting
is controllable or covered by a UV filter. Similarly, use the same UV
filtering in your finishing space and your resin storage location.
3.1.3 Ventilation
Resins and cleaning alcohol evaporate over time. These substances
can be corrosive to other equipment and may be harmful if
inhaled over a long period of time.
Keep your printer, resin, and storage space well ventilated at all
times. Keep the hood closed whenever possible and limit any
exposure to resins.
3.2 Connecting to a power source
This printer is Class I Equipment and the power cable must be con-
nected to a properly wired earth ground socket outlet. An improp-
erly wired outlet could cause hazardous voltages.
To Next Page
Loading...
