Ackuretta SOL - 6.2 Cleaning the Vat

46
6.2 Cleaning the vat
If you want to change resins or check the vat film for damage, it is
best to completely clean the vat.
Tip: We strongly
recommend
keeping a differ-
ent vat for each
type of resin that
you use instead
of cleaning the
vat every time
you want to
change resins.
Make sure to
store all vats with
resin in a dry,
dark location.
Cleaning the vat takes approximately 15 minutes.
You will need:
• A clean, dry, opaque bottle;
• A funnel;
• A mesh filter (optional);
• Cleaning alcohol (70% or higher ethanol or 90% or higher iso-
propyl alcohol;
• Some stiff paper or cards;
• A silicon or rubber spatula (optional);
• Tissues;
• A bin and clear plastic bag;
• Air compressor or blower (optional); and
Note: We strongly
recommend that
you wear a respira-
tor if you are work-
ing with 3D
printing materials
for an extended
period of time.
• Personal protective equipment (PPE), i.e. chemical resistant
gloves.
To clean the vat:
Step 1 Prepare a bin and clear plastic bag to collect the
waste.
Step 2 Put the funnel and mesh filter in place on the bottle.
Step 3 Remove the vat from your printer.
Caution You must always remove the build platform before
removing the vat from the printer.