45
Step 6 Use a piece paper or card to lift a corner of the cured
layer and peel the layer off the vat film.
• If the paper is saturated with resin, dispose of it
and get another piece so that the process is eas-
ier and there is less chance of making a mess.
Step 7 Remove the layer of cured resin and allow any excess
resin to drip off the cured layer.
Step 8 Put the cured layer in the bin.
Result of this task: You can now clean the vat or put the vat back
in place and start the print process again.
More info: You can always press the Tip button in
the top-left corner to get directions while using the
printer
To Next Page
Loading...
