25
for if you forget to attach the build platform or make a mistake
with your printing setup.
• When the print process starts and the first layer of resin is
cured, the Cancel button changes to show a Pause button. You
can press Pause to temporarily stop the printer so that you can
add more resin or see if the print has failed. When you press
Pause, the printer cures the current layer before making any
other options available.
• When the printer is paused, two new options become available:
• Resume - If the print is paused, press the Resume button to
continue printing.
• Stop - Press the Stop button to end the print process so you
can clean the build platform and start printing a new print. You
cannot undo this action.
• When you stop the print process, the printer finishes printing
the current layer before showing the Home screen again. The
build platform then moves to the top of the Z-axis tower.
To Next Page
Loading...
