INDEX 3
SB1391 Hardware and Setup Guide - Document revision no. 1.14
digital inputs, 7-10
digital outputs
ACSPL, 7-10
DIP Switch
COM_SD, 4-34
PROG., 4-34
DIP switches, 4-34
direct mode, 5-49
display
7-segment, 4-33
seven-segment, 4-33
drive
supply, 4-6
Drive Supply
connector, 4-6
dual loop control, 6-24
E
EA parameter, 5-28
Early Ready motion state, 7-11
encoder, 4-18, 7-9
ACSPL, 7-9
master, 4-24
supply, 4-20
encoder 1, 7-9
Encoder 1+Hall/Resolver
connector, 4-18
encoder 2, 7-9
Encoder 2 connector, 4-24
ER parameter, 5-28
error
maximum, 5-28
monitoring, 7-13
position, 7-13
Error limit (ER) parameter, 5-28
Error limit during accel./decel. (EA) parameter,
5-28
error messages
25, 5-28
27, 5-28
error, following, 6-1, 6-22
F
Fan 24Vdc
Connector, 4-14
FEATURES, 3-1
feedback
encoder, 4-18
Hall sensors, 4-19
resolver, 4-22
Field Current FC parameter, 8-4
filter
low pass, 6-15
proportional-integral, 6-16
following error, 6-1, 6-22
fuse, 4-33
regeneration resistor, 4-13
G
grounding, 2-5
H
Hall
connector, 4-18
sensors, 4-19, 7-9
supply, 4-20
Hall sensors
ACSPL, 7-9
high speed serial interface, 4-31
HSSI, 4-31
HSSI/PEG
connector, 4-31
I
I/O, 4-24
ACSPL, 7-10
analog, 4-30
To Next Page
Loading...