ACS Tech80 SB1391 - Page 180

INDEX 5
SB1391 Hardware and Setup Guide - Document revision no. 1.14
digital, 4-29
P
parameters
CL, 5-28
EA, 5-28
ER, 5-28
TL, 5-28
TO, 5-28
PEG, 4-31
Peg Mask (PM) parameter, 7-11
phase advance, 6-24
DC brushless motor, 6-24
Phase R, 4-11
phase S
test point, 4-35
Phase S, 4-11
phase T
test point, 4-35
Phase T, 4-11
Phoenix Contact
connectors, 4-10
point to point move, 5-50
ACSPL, 5-56
points
test, 4-34
polishing, 6-22
position
error, 7-13
Position Event Generator, 4-31
position loop
tuning, 6-18
power
connectors, 4-5
line filter, 4-7
power cable, 2-4
powering on, 5-3
PROG. DIP switch, 4-34
Protective Earth, 4-11
Protective Earth., 4-7
R
Ready motion state, 7-11
Regen
connector, 4-12
regeneration resistor fuse, 4-13
regeneration, external, 4-13
repetitive point to point move, 5-51
resolver, 4-22
routing cables, 2-4
RS232, 7-3
RS-232, 7-2
ACSPL, 7-2
multiple drop configuration, 7-2
RS-232/422
connector, 4-15
RS-422
ACSPL, 7-2
RS-422/485, 7-2
multiple drop configuration, 7-4
RS-485
ACSPL, 7-2
S
safety, 4-24
inputs, 7-10
safety inputs
ACSPL, 7-10
Saver, 5-65
SB-SHUNT, regeneration, external, 4-13
searching for index, 5-63
secondary encoder, 4-24
sensor
Hall, 4-19
sensors
motor temperature, 4-23