Acteon X-MIND trium - Page 49

49
ENGLISH
USER MANUAL• X-Mind trium • (13) • 03/2018 • NTR0EN010M
105 C
"OVER_CURRENT_ON_POS
Inverter board error:
GENERAL STATE ERROR, bit 10 -
OVERCURRENT ON POSITIVE STAGE"
T
Reset error from AIS software on workstation;
if error remains restart X-MIND trium and workstation;
If error remains technical service is required.
106 C
"OVER_CURRENT_ON_NEG
Inverter board error:
GENERAL STATE ERROR, bit 11 -
OVERCURRENT ON NEGATIVE STAGE"
T
Reset error from AIS software on workstation;
if error remains restart X-MIND trium and workstation;
If error remains technical service is required.
107 C
"VOLT_LOW_LIM_ON_POS
Inverter board error:
GENERAL STATE ERROR, bit 12 -
VOLTAGE TOO LOW ON POSITIVE
STAGE"
T
Reset error from AIS software on workstation;
if error remains restart X-MIND trium and workstation;
If error remains technical service is required.
108 C
"VOLT_UPP_LIM_ON_POS
Inverter board error:
GENERAL STATE ERROR, bit 13 -
VOLTAGE TOO HIGH ON POSITIVE
STAGE"
T
Reset error from AIS software on workstation;
if error remains restart X-MIND trium and workstation;
If error remains technical service is required.
109 C
"VOLT_LOW_LIM_ON_NEG
Inverter board error:
GENERAL STATE ERROR, bit 14 -
VOLTAGE TOO LOW ON NEGATIVE
STAGE"
T
Reset error from AIS software on workstation;
if error remains restart X-MIND trium and workstation;
If error remains technical service is required.
110 C
"VOLT_UPP_LIM_ON_NEG
Inverter board error:
GENERAL STATE ERROR, bit 15 -
VOLTAGE TOO HIGH ON NEGATIVE
STAGE"
T
Reset error from AIS software on workstation;
if error remains restart X-MIND trium and workstation;
If error remains technical service is required.
111 C
"HI_VOLTS_ARC_ON_POS
Inverter board error:
GENERAL STATE ERROR, bit 16 - ARC
DETECTED ON POSITIVE HV"
T
Reset error from AIS software on workstation;
if error remains restart X-MIND trium and workstation;
If error remains technical service is required.
112 C
"HI_VOLTS_ARC_ON_NEG
Inverter board error:
GENERAL STATE ERROR, bit 17 - ARC
DETECTED ON NEGATIVE HV"
T
Reset error from AIS software on workstation;
if error remains restart X-MIND trium and workstation;
If error remains technical service is required.
113 C
"ANOD_CURRENT_ABSENT
Inverter board error:
GENERAL STATE ERROR, bit 19 -
ANODIC CURRENT ABSENT"
T
Reset error from AIS software on workstation;
if error remains restart X-MIND trium and workstation;
If error remains technical service is required.
114 C
"ANOD_CURR_LOW_LIMIT
Inverter board error:
GENERAL STATE ERROR, bit 20 -
ANODIC CURRENT TOO LOW"
T
Reset error from AIS software on workstation;
if error remains restart X-MIND trium and workstation;
If error remains technical service is required.
115 C
"ANOD_CURR_UPP_LIMIT
Inverter board error:
GENERAL STATE ERROR, bit 21 -
ANODIC CURRENT TOO HIGH"
T
Reset error from AIS software on workstation;
if error remains restart X-MIND trium and workstation;
If error remains technical service is required.
116 C
"HEAT_SINK_OVER_TEMP
Inverter board error:
GENERAL STATE ERROR, bit 23 - HEAT
SINK OVER TEMPERATURE"
T
Reset error from AIS software on workstation;
if error remains restart X-MIND trium and workstation;
If error remains technical service is required.