ActionTec SBWD100B - Specifying the Screenbeam CMS for the Receiver

48
3. Click the Apply button, and then click OK on the pop-up message box to confirm.
5.3.21. Specifying the ScreenBeam CMS for the Receiver
Follow the procedure below to specify a management server for the receiver:
1. Go to the Remote Management tab page by clicking the Remote Management tab.
2. Go to the Central Management System Setting section, and define the CMS Host and
the CMS Port.
 CMS Host: It is the IP address or the FQDN/hostname/domain name/alias name (if you
have properly configured the DNS server and the DHCP server) of the server that hosts
the ScreenBeam CMS. It supports a domain with six labels at most.
Note: We recommend using the DNS setting.
 CMS Port: It is the communication port of the ScreenBeam CMS.
3. Click the Apply button, and then click OK on the pop-up message box to confirm.