ActionTec SBWD100B - Resetting the Receiver to Default

49
5.3.22. Rebooting the Receiver
Follow the procedure below to reboot the receiver:
1. Go to the Maintenance tab page by clicking the Maintenance tab.
2. Click the Yes button next to “Reboot Receiver”.
3. Click OK on the pop-up message box to confirm.
5.3.23. Resetting the Receiver to Default
Follow the procedure below to reset the receiver:
1. Go to the Maintenance tab page by clicking the Maintenance tab.
2. Click the Yes button next to “Reset Settings to Factory”.