50
3. Click OK on the pop-up message box to confirm.
4. The receiver reboots, and the receiver is reset to factory defaults after the reboot.
Note: All settings will be reset to defaults.
5.4. Updating Firmware for the Receiver
Users can wirelessly upgrade firmware for the receiver through the local web management
console. Follow the procedure below to upgrade your receiver:
1. Download the latest firmware from Actiontec’s website:
http://www.actiontec.com/sbupdate
Note: You should disconnect from the receiver’s SSID and connect to a router’s SSID
before downloading firmware.
2. Log into ScreenBeam Pro’s web server, and go to the Firmware Upgrade tab page by
clicking the Firmware Upgrade tab.
On the Firmware Upgrade tab page, you can check the current firmware version in the
Firmware Version section.
Note: You can update the receiver’s firmware to a higher version only.
3. Click the Browse button to display the Choose File to Upload dialog box.
To Next Page
Loading...
Need help?
General
