7451A/7461A/7461P Digital Multimeter Operation Manual
6.7.4 SCPI Command Reference
6-41
Whether to set the calculation
result HI to PASS.
:CALCulate:LIMit:PASS:UPPer {ON,1|OFF,0} {1|0}
Buzzer setting :CALCulate:LIMit:BEEPer {OFF|FAIL|PASS} {OFF|FAIL|PASS}
Statistical calculation
Calculation range specifying
and performing
:CALCulate:STATistics [0|0|9999], [0|-1|9999] <int_4>,<int_4>
Number of samples reading :CALCulate:STATistics:COUNt? <real_6> (7461A/61P)
<real_5> (7451A)
Maximum value reading :CALCulate:STATistics:MAXimum?
Minimum value reading :CALCulate:STATistics:MINimum?
Average value reading :CALCulate:STATistics:AVERage?
Standard deviation value read-
ing
CALCulate:STATistics:DEViation?
MAX-MIN reading CALCulate:STATistics:MAXMin?
dB/dBm
Calculation setting :CALCulate:DB {DB|DBM|OFF} {DB|DBM|OFF}
Constant D setting :CALCulate:DB:D {[0.000001E-9|1|
9999999.E+6]|
MEASurement}
(7461A/61P)
{[0.000001E-9|1|
999999.E+6]|
MEASurement}
(7451A)
<real_6> (7461A/61P)
<real_5> (7451A)
Digital output *7461P only
Enable/Disable setting :DOUTput:STATe {ON,1|OFF,0} {1|0}
Output setting :DOUTput:BITS {0-31}
Refer to Section 6.6,
"Digital Output
(7461P Only)."
{0-31}
Function description SCPI Command Parameter Query reply
To Next Page
Loading...
Need help?
General
