ADT ACCORD XPC User Manual

33
Accord xpC - July, 2001
The communicator still attempts to dial out in the event of an alarm, even if a Line Fail
condition has been detected. When the panel cannot dial due to the Line Fail condition
the Comm Fail indication flashing ( ) does not override the Line Fail indication solid
( ).
This option defaults to 1 (enabled).
Group 7 — Option 8 Downloader Options
This option determines under what set conditions the Ademco Microtech Downloader
software may access the Accord xpC panel. There are three options:
0. Full Access.
1. No Access When Set.
2. No Unsetting.
This option defaults to 1 (No access when set).
Full Access (0), permits access at any time and the Downloader software can perform all
system operations.
No Access When Set (1), prevents access in any (Full, Part or Night) set condition. The
system must first be unset from the site, before the Downloader software can perform all
system operations.
No Unsetting (2), permits access the system to perform a download at any time. However,
the Downloader cannot unset the system from a set condition.
Group 7 — Option 9 Zone Auto Omit
This option determines the number of times a zone can activate during a set period
before it is omitted from the system. There are two options:
0. Two activations during a set period then the zone is omitted.
1. One activation during a set period then the zone is omitted.
This option defaults to 0 (Two activations).
Table 3.13 Group 8—Triggers
This option is used to enable/disable the
communications triggers. The triggers are
outlined in Table 3.13.
droccA XP sreggirTC
.oNreggirTreggirTtluafeD
1eriFdelbanE
2)tneliSAP+(APdelbanE
3redurtnIdelbanE
4tesnU/teSdelbasiD
5srepmaTyaDdelbasiD
6trobAdelbasiD
7mralAdeifireVdelbasiD
8liaFCA/woLttaBdelbasiD
9tropeRtseTdelbasiD
System Programming – Group 8 Communication
Enable / Disable

ADT ACCORD XPC Specifications

General

Brand	ADT
Model	ACCORD XPC
Category	Security System
Language	English