To Next Page

To Previous Page

Accord xpC - July, 2001

Section 4: Operating The Accord

Setting and Unsetting the System

Before setting the system:

• Ensure all doors and windows are secure.

• Ensure movement detectors are not obstructed.

Full Set 1 ( )

To Full Set the system:

• Enter your User Code then press the 1 (Full Set) key.

• A constant exit tone is heard which changes to a broken tone as you pass the

detectors (except Final Exit zones) on the exit route.

• The full set icon ( ) will flash during the Exit Time.

• To cancel the setting procedure press the Ö key.

• When the system sets, two confirmation beeps are emitted by the keypad and

internal speaker. The Ö key will no longer function.

Easy Set allows users to Set the system without entering a User Code. If Easy Set is

programmed you may set the system by pressing the # key, then the 1 (Full Set) key. See

SECTION 3: Programming the Accord; Group 4 — Option 8 Easy Set.

Part Set 2 (

)

To Part Set the system:

• Enter your User Code then press the 2 (Part Set) key.

• This starts the setting of the system using the Part Set zone programming. This

allows a sub-set of the system to be set.

• The Part Set icon ( ) will flash during the Exit Time.

• To cancel the setting procedure press the Ö key.

• When the system sets two confirmation beeps are emitted by the keypad and

internal speaker; after this the Ö key does not function.

Note: The activation of the keypad buzzer and internal speaker are dependant on the

programming of Group 4 — Option 4 Part Set Exit Warning.

Easy Set allows users to Part Set the system without entering a User Code. If Easy Set is

programmed the system may be set by pressing the # key, then the 2 (Part Set) key. See

SECTION 3: Programming the Accord; Group 4 — Option 8 Easy Set.

ADT ACCORD XPC User Manual

Questions and Answers: