52
Remote Keypad Specification
Connected via a three wire terminal block on the back of the keypad.
Built in piezo warning sounder
PhysicalWidth: 120 mm
Height: 120 mm
Depth: 25 mm
Electrical Voltage Input: 12 V d.c.
Current Drain: 50 mA (typical), 100 mA (maximum)
Appendix B: Connecting a Printer to the System
Installing a Printer
Two printer leads are required to connect the Accord xpC panel to a serial printer.
1. Master Printer Lead (part no. 2011-095) connects from the Printer to the Adapter
Printer Lead.
2. Adapter Printer Lead (part no. 2011-096) connects from the Control Panel to the
to the Master Printer Lead.
The Adapter Printer Lead connects to the control panel using a 3 wires connection:•
Yellow wire to LS terminal
• Red wire to +Aux(12V)
• Black wire to -Aux(0V)
The serial printer should have the following setting:
• Baud Rate 1200 • Data Bits 8
• Parity None • Start Bits 1
• Stop Bits 2
To Next Page
Loading...
