To Next Page

To Previous Page

Accord xpC - July, 2001

• Enter your User Code.

• Press: 9 3 5.

• Two beeps confirm that the Chime function has been assigned to these zones.

• Zones three and five now have the Chime option enabled.

Disabling the Chime Function on All Zones

To disable the Chime function on all zones, enter your User Code, select the Chime

option by pressing 9, then press the Ö key.

Note: The Chime function cannot be disabled on individual zones. However, the

chime function on a zone is deleted when entering and exiting programming

mode.

Viewing the Event Log from a System Keypad

To view the 16 Event Log:

• Enter a valid User Code and press 0.

• The most recently activated zone number is displayed and the keypad beeps

once.

• The system works its way through the history of the zone activations.

• If a zone has been activated two or more times in succession the zone number

will display and the keypad beeps for each activation.

• Hotkey conditions are indicated by scrolling numbers.

• The keypad beeps twice in rapid succession at the end of the Log display.

The Ö key can be used to terminate event log veiwing at any time.

Viewing the Event Log from Ademco Microtech Downloader Software

The Ademco Microtech Downloader software allows the 250 Event Log of the Accord

xpC panel to be viewed. The log stores 250 time and date stamped events.

Viewing the Event Log through the keypad is restricted to the last 16 alarm events (with

no time/date stamp), only by using the Downloader software or a serial printer, can the

full 250 events and the time/date be viewed.

Printing the Event Log

The Event Log can be printed in full by a serial printer connected to the AUX

supply and loudspeaker terminal via a 4110 Printer Lead (Part No. 2011-095)

and adapter (Part No. 2011-096). A Print option is provided in Group 9 —

Option 7 Print Event Log.

Programming the Time and Date

The time and date may be set through the keypad by entering any valid code and

pressing # 0 (Log) then DDMMYYHHMM where DD is the day of the month (01 – 31),

ADT ACCORD XPC User Manual

Questions and Answers: