ADT ACCORD XPC User Manual

34
Group 8 — Option 1 Communicate Fire
This option has two settings:
0. No (Fire Comm disabled).
1. Yes (Fire Comm enabled).
This option defaults to 1 (Fire Comm enabled).
Group 8 — Option 4 Communicate Set/Unset
This option has two settings:
0. No (Set/Unset Comm disabled).
1. Yes (Set/Unset Comm enabled).
This option defaults to 0 (Set/Unset Comm disabled).
Group 8 — Option 6 Communicate Abort
This option has two settings:
0. No (Abort Comm disabled).
1. Yes (Abort Comm enabled).
This option defaults to 0 (Abort Comm disabled).
Group 8 — Option 2 Communicate PA Signals (PA and PA Silent)
This option has two settings:
0. No (PA Comm disabled).
1. Yes (PA Comm enabled).
This option defaults to 1 (PA Comm enabled).
Group 8 — Option 3 Communicate Intruder
This option has two settings:
0. No (Intruder Comm disabled).
1. Yes (Intruder Comm enabled).
This option defaults to 1 (Intruder Comm enabled).
Group 8 — Option 5 Communicate Tamper
This option has two settings:
0. No (Tamper Comm disabled).
1. Yes (Tamper Comm enabled).
This option defaults to 0 (Tamper Comm disabled).
Note: Tamper communication is only sent during unset mode. A Tamper during set
(Full, Part or Night) condition, on any zone type, results in an Intruder signal
being sent.

ADT ACCORD XPC Specifications

General

Brand	ADT
Model	ACCORD XPC
Category	Security System
Language	English