Adtech ADT-CNC4620 User Manual

Adtech CNC Technology Co., Ltd. 11. System parameters
- 59 -
075 ExScram ELevel
082 ExStart ELevel
083 ExPause ELevel
Range : 0~1
Unit : LOGIC VOLTAGE LEVEL
Authority : Operation admin or higher
Default : 0
Effective time : Instant
Note : External emergency stop button of the system
This port is affected by IO configuration.
077 Arc Acc.for Radii
078 Arc Acc.for Speed
Range :
Unit : Coefficient
Authority : Operation admin or higher
Default : 50, 100
Effective time : Instant
Note : Used to restrict the arc processing speed automatically. This parameter is
valid in pretreatment mode.
The bigger the radius coefficient is, the lower the arc speed is.
The bigger the acceleration coefficient is, the higher the arc speed is.
079 PretreatmentCode Set
Range : 100~1000
Unit : Instruction line
Authority : Operation admin or higher
Default : 500
Effective time : Instant
Note : Set the pre-reading instruction lines; if the pretreatment processing
pauses and pre-reads, please increase this value to pre-read more
instructions.
080 Inp AccSpeed Mode
081 'S'Speed Acceleration
Range :
Unit :
Authority : Operation admin or higher
Default :
Effective time : Instant
Note : Used to set the performance of S curve acceleration/deceleration
084 HOME Check for alarm
085 HOME Check Enable
Range : 0~1
Unit :
Authority : Operation admin or higher
Default : 0, 1
Effective time : Instant
Note : Used to set whether prompt user to reset under certain conditions,
ensuring that the user has performed the operation;
If the value is set to 0, it won’t check, and will run directly.
086 X diameter prog enable
Range : 0~1
Unit :
Authority : Operation admin or higher

Adtech ADT-CNC4620 Specifications

General

Brand	Adtech
Model	ADT-CNC4620
Category	Controller
Language	English