Adtech ADT-CNC4620 User Manual

Adtech CNC Technology Co., Ltd. 11. System parameters
- 69 -
Range : 1~90000
Unit :
Authority : Super Admin
Default : 90000
Effective time : Instant
Note : Used to configure the restriction acceleration of every axis during
pretreatment processing.
No matter which parameter, the lower the setting is, the slower the
processing speed is; vice versa.
The setting value should be as high as possible if each axis permits.
In comprehensive parameter P1.58 (interpolation speed mode), this
parameter is valid if it is set to 1; the default setting is invalid.
11.4 Management parameters (P3.)
001 Select SupMode
002 AlterSuperuserPasswor
003 Alter User Password
Range : None
Unit : None
Authority : None
Default : None
Effective time : Instant
Note : In this menu, type the password and press ‘Insert’. If the password is
valid, the system will enter this user mode;
After entering, this menu will turn into “Exit XXX admin mode”,
indicating entering successfully;
In the new menu, press the Insert key to exit the admin mode. To modify
the parameter table at this moment, you need to enter the admin mode
again;
The super user can modify all passwords, while the operation user only
can modify the own password.
Password 0 indicates that the password isn’t checked in this mode; it isn’t
required to enter the admin mode to modify the parameters.
004
Initialize
005
Initialize IO Config
006
all para reset<●>
Range : None
Unit : None
Authority : Super user
Default : None
Effective time : Instant
Note : Initial parameter table only in super user mode

Adtech ADT-CNC4620 Specifications

General

Brand	Adtech
Model	ADT-CNC4620
Category	Controller
Language	English