User Manual of TV5600-B01 Series Dispensing Control System
After the above parameters are configured, the processing file can be edited. The editing method
of the extrusion processing file is the same as that of dispensing. There is no need to set the
coordinates of the extrusion axis. After the operation, the extrusion axis will extrude at the set
running speed. The speed is set in the file parameters:
It can be used after setting.
extrusion axis moves upward (coordinatesdecrease), and the speed is manual
high speed.
5) High and Low speed switch in downward: Downward speed switching button,
Switch the manual downward speed; press it down to select high speed and
release it to select low speed
6) auto_back input: Push-to-return button,When the button is pressed, the
extrusion axis automatically returns to the negative limit
7) dj speed: Dripping speed, The speed of the extrusion axisduring manual
dripping and automatic dripping
8) Hand low speed: Extrusion shaft manual low speed
9) Hand high speed: Extrusion shaft manual high speed
To Next Page
Loading...
Need help?
General
