Page 28 of 42
[Extract Settings]
EXTRACT MINS: 0 .
EXTRACT MODE:
MANUAL PROMPT
Use the ÏÐ buttons to highlight the required option and
then press the button to select it.
The table below details each available option.
Parameter Comments / Description Options Default
Setting
EXTRACT MINS Specifies the duration of the extract signal following
release of the extinguishant.
0 – 120 Minutes
0
EXTRACT MODE Specifies whether the panel should prompt to start the
extract phase or whether the extract output should turn on
immediately following discharge.
MANUAL PROMPT
AUOTMATIC
MANUAL
PROMPT
To Next Page
