Advanced Electronics Ex-3000 Series - Table of Contents

Page 3 of 42
Table of Contents
1 INTRODUCTION __________________________________________________________ 5
1.1 Standards ____________________________________________________________ 5
1.2 Cautions and Warnings__________________________________________________ 5
1.3 Description ___________________________________________________________ 5
1.4 EN54 Functions _______________________________________________________ 6
1.5 EN54 Optional Features with Requirements__________________________________ 6
1.6 EN12094-1 Optional Features with Requirements _____________________________ 7
1.7 Installation Approvals ___________________________________________________ 8
1.7.1 Fire System Installations _____________________________________________ 8
1.7.2 Wiring Regulations__________________________________________________ 8
2 INSTALLATION___________________________________________________________ 9
2.1 Identification of Parts ___________________________________________________ 9
2.2 Installing the back box _________________________________________________ 10
2.3 Wiring Installation _____________________________________________________ 11
2.3.1 AC Mains Wiring __________________________________________________ 11
2.3.1.1 Cable Gland ___________________________________________________________ 11
2.3.2 Battery Wiring ____________________________________________________ 11
2.3.3 24VDC Power Supply Wiring_________________________________________ 12
2.3.4 External Wiring ___________________________________________________ 12
2.3.4.1 Relay Outputs __________________________________________________________ 13
2.3.4.2 RS485 Communications __________________________________________________ 13
2.3.4.3 AUX DC Supply Output___________________________________________________ 14
2.3.4.4 Detection Zone Inputs ____________________________________________________ 14
2.3.4.5 Sounder / Monitored Output Circuits_________________________________________ 15
2.3.4.6 Input Circuits ___________________________________________________________ 16
2.3.4.7 Actuator Output Circuit ___________________________________________________ 17
2.3.4.8 USB__________________________________________________________________ 18
2.3.4.9 Recommended Cable Routing _____________________________________________ 18
2.4 Key-Switch Installation _________________________________________________ 19
2.5 Adjusting the LCD Contrast______________________________________________ 19
2.6 Loading Calculations___________________________________________________ 20
2.6.1 Panel Loading ____________________________________________________ 20
2.6.2 Battery Standby Calculation__________________________________________ 20
3 PROGRAMMING _________________________________________________________ 21
3.1 Introduction __________________________________________________________ 21
3.1.1 Access Levels ____________________________________________________ 21
3.1.2 Front Panel Controls and Indications___________________________________ 21
3.1.3 Enable Controls ___________________________________________________ 22
3.1.4 Navigating through menus___________________________________________ 22
3.1.5 Numeric data entry_________________________________________________ 23
3.2 Recommended Programming Procedure ___________________________________ 23
3.3 Level 3 Menu Functions ________________________________________________ 23
3.3.1 Detection Zones___________________________________________________ 24
3.3.2 Alarms __________________________________________________________ 24
3.3.2.1 Sounder Configuration ___________________________________________________ 24
3.3.2.2 Pulse Pattern Configuration _______________________________________________ 25
3.3.3 Extinguishing _____________________________________________________ 26
3.3.3.1 Output Set-Up __________________________________________________________ 26
3.3.3.2 Cause and Effects Programming ___________________________________________ 27
3.3.3.3 Extract Set-Up__________________________________________________________ 27
3.3.3.4 Release Signal Termination (Test Function)___________________________________ 29
3.3.4 Inputs ___________________________________________________________ 29
3.3.5 Outputs _________________________________________________________ 29
3.3.5.1 Switched AUX Output ____________________________________________________ 30
3.3.6 Passwords _______________________________________________________ 31
3.3.6.1 Default Passwords ______________________________________________________ 31
3.3.7 General Options___________________________________________________ 31
3.3.7.1 Daylight Saving Options __________________________________________________ 32
3.3.8 Status Indicators __________________________________________________ 33
3.3.9 Enable PC LINK___________________________________________________ 33