Advanced Instruments 4C3 User Manual

81
Troubleshooting Table
If not followed by “Reset
Probe Configuration”, see
Chapter 5, Section C for
further assistance.
If followed by “Reset
Probe Configuration”, see
Symptom item “Reset
Probe Configuration”...
“Parameter
RAM Failed”
or “New
Software
Version”
“Reset Probe
Configuration”
displayed
during the
power-up
sequence
If not followed by “Select
Test Item”, see Chapter
5, Section C for further
assistance.
If followed by “Select
Test Item”, see Symptom
item “Thermoelectrics
Driver Failure”
“Reset Probe
Configuration”
displayed
during the
power-up
sequence,
followed by
“Select Test
Item”
(If not followed by
“Select Test Item”, see
Chapter 5, Section C for
further assistance.
a. Press > to advance
to “Set Block Probe
Bin #” in the SETUP
menu and reset the
block probe bin # (see
Chapter 1, Section
K.1).
Switch the instrument
off, then on.
If the error message
persists, see Chapter 5,
Section C for further
assistance.
Symptom
Check
Suggested Action

Advanced Instruments 4C3 Specifications

General

Brand	Advanced Instruments
Model	4C3
Category	Measuring Instruments
Language	English