OsmoPRO® Multi-Sample Micro-Osmometer User’s Guide
13
Figure 1.2: Cooling Assembly Shipping Stop
• Locate the white sample probe shipping stop with a red-capped thumb screw.
• Loosen the thumb screw two full turns.
• Lift the top section of the shipping stop upwards approximately ½”, (13 mm) and then
remove from the instrument (Figure 1.3).
• Reinstall the instrument’s rear panel.
Figure 1.3: Sample Probe Shipping Stop
NOTE: Any reshipment of the OsmoPRO requires reinstallation of the cooling assembly
shipping stop, and the sample probe shipping stop.
To Next Page
Loading...
