OsmoPRO® Multi-Sample Micro-Osmometer User’s Guide
64
8.3 Sample probe
From the Diagnostics screen, press SAMPLE PROBE to enter the Sample Probe screen
(Figure 8.4). Here, the user can run up to 20 tests using reagents, the results for the samples
tested display in Ohms. Press EXIT to return to the Diagnostics screen.
Figure 8.4: Sample Probe
To start a sample probe test:
• Select the position to load with a sample tube from the window using the arrows.
NOTE: On screen entry the system displays the next available tube position.
• Press LOAD.
• Turntable rotates to the selected tube position making it available for loading
• Load the sample onto the turntable.
• Press TEST.
Test Status is updated with test progress or error message, if any. The result is reported in
Ohms once the test is completed.
8.4 Barcode
From the Diagnostics screen, press BARCODE to view the Barcode screen. (Figure 8.5)
Figure 8.5: Barcode
To Next Page
Loading...
