OsmoPRO® Multi-Sample Micro-Osmometer User’s Guide
6
General cautions
• This product should be operated only with the type of power source indicated on the
product’s electrical ratings label. Refer to the installation instructions included with the
product.
• If the power cord provided is replaced for any reason or if an alternate cord is used, the
cord must be approved for use in the local country. The power cord must be approved
for the product’s listed operating voltage and be rated at least 20% greater than the
ampere ratings marked on the product’s electrical ratings label. The cord end connects
to the product must have an IEC 60320 connector.
• Plug the product into an approved grounded electrical outlet.
• Do not disable the power cord’s grounding plug.
• If an extension cord or power strip is used, make sure the cord or strip is rated for the
product, and the total ampere ratings of all products plugged into the extension cord or
strip do not exceed 80% of the cord’s or strip’s rating limit.
• Route power cords so they are not walked on, tripped on, or pinched by items placed
upon or against them. Pay attention to the plug, electrical outlet, and the point where the
cord exits the product.
• Do not pull on cords and cables. When unplugging cords or cables, grasp the
corresponding connector.
• Do not install or use this product in any area subject to extreme short-term temperature
variations, or locations exceeding the specified operating environment temperatures.
• Never use this product in a wet area.
• To avoid injury or fire hazard, do not operate this product in an explosive atmosphere.
• Do not install or use the product on an unstable, non-level work surface.
• Do not operate this product with the covers removed or unsecured.
To Next Page
Loading...
