Advanced Instruments OsmoTECH PRO - Connecting to a Network

• Step 6 – Connecting to a network (optional)
• To connect the OsmoTECH PRO to a laboratory information system (LIS), OPC-UA, to a local area
network (LAN), and/or to enable the webserver, plug an Ethernet cable that connects to your
network into the Ethernet port on the back of the OsmoTECH PRO unit.
• Refer to the User Guide to configure the communication settings in the OsmoTECH PRO
software and Data management guide for more information.
Installation and Setup