To Next PageTo Next Page
Need help?Do you have a question about the AEQ SYSTEL IP 16 and is the answer not in the manual?
Introduces Dante Virtual Soundcard software as a complement for AEQ systems.
Covers routing terminology, unicast/multicast, subscriptions, and redundancy in Dante audio routing.
Explains Dante's IEEE 1588 PTP clock synchronization and master/slave configurations.
Discusses Dante latency settings, compensation, and issues with virtual soundcards.
Details the Device Lock feature for securing Dante devices with a PIN.
Provides a description of the Dante Controller software and its functionalities.
Guides on how to download and install the Dante Controller application.
Guides on configuring Dante Controller to communicate with Dante networks via Ethernet/Wi-Fi.
Explains how to use the Network View in Dante Controller for network connection visualization.
Details the Routing tab, showing device connections in a grid format for subscriptions.
Explains the Device Info tab, providing an overview of device configuration and operating info.
Describes the Clock Status tab for viewing network-wide clocking states and sync status.
Details the Network Status tab for viewing network traffic, bandwidth, and latency issues.
Explains how to use Device View to modify detailed information and settings for a specific device.
Lists and describes the tabs within Device View: Receive, Transmit, Status, Latency, Device Config, Network Config, AES67 Config.
Details the Receive tab for viewing and creating subscriptions for device receive channels.
Explains the Transmit tab for inspecting and modifying device transmit configurations.
Describes the Status tab for obtaining current information about a Dante device's status.
Details the Latency tab for viewing audio packet latency histograms and identifying issues.
Explains the Device Config tab for configuring device-specific parameters like name, sample rate, and encoding.
Details the Network Config tab for configuring network settings like redundancy and IP addresses.
Guides on configuring multicast transmit flows using Dante Controller.
Introduces Dante Controller presets for saving and loading network configurations and device settings.
Guides on downloading and installing the Dante Virtual Soundcard application.
Guides on configuring Dante Virtual Soundcard settings via its Control Panel and Dante Controller.
Guides on using Dante Virtual Soundcard with audio applications.
Describes the Dante Firmware Update Manager application for upgrading firmware.
Provides a step-by-step procedure for upgrading DANTE device firmware using the manager.
Guides on troubleshooting IP address configuration issues in Dante networks.
Provides troubleshooting steps for network switch configuration and cable issues.
Details the configuration software for FORUM and CAPITOL IP consoles.
Describes the Hardware Configuration menu for setting up internal modules.
Details the Board Configuration submenu for configuring MADI/AOIP/AES links.
Explains the I/O Configuration submenu for input/output settings.
Describes the Programmable Configuration menu for advanced settings.
Details the Routing Configuration submenu for defining cross-points.
Explains the SnapShot Configuration submenu for managing console memories.
Provides information on selecting and configuring DANTE-based AEQ AoIP Ethernet Switches.
Guides on configuring Cisco SG200 switches for use with AEQ AoIP systems.
General| Number of lines | 16 |
|---|---|
| Ethernet Ports | 2x 10/100/1000 Mbps RJ45 |
| Audio Codecs | G.711, G.722, OPUS |
| Supported Protocols | SIP, RTP |
| Power Supply | 100 to 240 VAC, 50/60 Hz |
| Operating Temperature | 0°C |
| Weight | 3.5 kg |
| Dimensions | 483 x 44 x 266 mm (19 x 1.73 x 10.5 in) |
