AEQ Audio Over IP
Routing System
131
In the case of NETBOX DSP 128, "Dante Controller" will show the main module with the
previously described channels and 2 additional devices corresponding to the 2 additional
modules with 32 transmission / reception channels per module (named as NBOXDSP_1L,
NBOXDSP_1R, NBOXDSP_2L... NBOXDSP_15R, NBOXDSP_16L and NBOXDSP_16R).
In the case of NETBOX DSP 160, "Dante Controller" will show the main module with the
previously described channels and 3 additional devices corresponding to the 3 additional
modules with 32 transmission / reception channels per module (named as NBOXDSP_1L,
NBOXDSP_1R, NBOXDSP_2L... NBOXDSP_15R, NBOXDSP_16L and NBOXDSP_16R).
The main module could be labelled in "Dante Controller" as NETBOXDSP and the additional
modules as NETBOXDSP-AD1, NETBOXDSP-AD2 and NETBOXDSP-AD3 in order to identify
them (or with any other name that allows to identify them easily on each installation).
NOTE 3: The previous tables show the names of the input/out lines and reception/transmission
channels that are configured by default. These last ones can be edited by means of "Dante
Controller" application, just like the device names, depending on each installation
characteristics.
To Next Page
Loading...
Need help?
General
