48
SET SRT ALARM, information includes (Fig. 45) -
> Graphic SRT (meaning Surface Recovery Time)
> Time Set Point (min:sec), flashing if ON is selected, with SURF and TIME
icons
> Set Point ON or OFF, flashing
• Pressing/releasing the S button momentarily (< 2 seconds) will toggle
between ON and OFF.
• Pressing/releasing the A button momentarily (< 2 seconds) will accept the
ON/OFF setting.
> If OFF is accepted, operation will advance to the Set EDT screen.
> If ON is accepted, the Time Set Point value (min:) will flash.
• Depressing and holding the S button will scroll upward through the Set
Points at a rate of 8 per second from 1: to 30: (min:sec) in increments of 1
minute.
• Pressing and releasing the S button momentarily and repeatedly (< 2
seconds each time) will step upward through the Set Points one at a time.
• Pressing and releasing the M button momentarily and
repeatedly (< 2 seconds each time) will step back through
the Set Points one at a time.
• Pressing and releasing the A button momentarily (< 2
seconds) will accept the Set Point and access Set EDT
Alarm.
• Depressing the M button for 2 seconds, or if no button is
pressed during a period of 2 minutes, operation will revert
the SURF MAIN screen.
Fig. 45 - SET SRT
ALARM
To Next Page
Loading...
