Aeris F10 - Set RDI (Repeating Depth Interval)) Alarm

50
SET RDI ALARM, information includes (Fig. 47) -
> Graphic RDI (meaning Repeating Depth Interval)
> Depth Interval Set Point value, flashing if ON is selected, with FT (or M) icon
> Set Point ON or OFF, flashing
• Pressing/releasing the S button momentarily (< 2 seconds) will toggle
between ON and OFF.
• Pressing/releasing the A button momentarily (< 2 seconds) will accept the
ON/OFF setting.
> If OFF is accepted, operation will advance to Set DD 1.
> If ON is accepted, the Depth Set Point value will flash.
• Depressing the S button will scroll upward through the Set
Points at a rate of 8 per second from 10 to 100 FT (3 to
33 M) in increments of 10 FT (3 M).
• Pressing and releasing the S button momentarily and
repeatedly (< 2 seconds each time) will step upward
through the Set Points one at a time.
• Pressing and releasing the M button momentarily and
repeatedly (< 2 seconds each time) will step back through
the Set Points one at a time.
• Pressing and releasing the A button momentarily (< 2
seconds) will accept the Set Point and access Set DD 1.
• Depressing the M button for 2 seconds, or if no button is
pressed during a period of 2 minutes, operation will revert
the SURF MAIN screen.
Fig. 47 - SET RDI
ALARM