EasyManuals Logo

AERMEC MODUCONTROL Usage Manual

AERMEC MODUCONTROL
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #31 background imageLoading...
Page #31 background image
65
GB
6343841_00 / Ver - 4.20
ADDRESS DESCRIPTION
17 High pressure switch pre-alarm
18 Flow switch/differential pressure switch (water) pre-alarm
19 Low pressure switch pre-alarm
20 Pre-alarm for absence of NTC1 input probe (SIW)
21 Pre-alarm for absence of NTC2 input probe (SUW)
22 Anti-freeze pre-alarm
23 Pre-alarm for absence of NTC4 input probe (SGP)
24 Pre-alarm for high discharge gas temperature
25 Pre-alarm for absence of compressor delivery transducer
26 High pressure pre-alarm
27 Pre-alarm for absence of NTC3 input probe (SS)
28 Pre-alarm for absence of suction transducer
29 Low pressure pre-alarm
30 Low output pre-alarm
31 Pump thermomagnetic switch pre-alarm
32 High pressure capacity control pre-alarm
33 Low pressure capacity control pre-alarm
34 Discharge temperature capacity control pre-alarm
35 Bemf error pre-alarm (longertek inverter)
36 Pre-alarm for internal communication error (longertek)
37 Overcurrent pre-alarm (longertek)
38 Pre-alarm for absence of load (longertek)
39 Pre-alarm for incorrect voltage (longertek)
40 Pre-alarm for start-up error (longertek)
41 Pre-alarm for IPM protection error (longertek)
42 Pre-alarm for EEPROM error (longertek)
43 Pre-alarm for compressor stalling (longertek)
44 Pre-alarm for absence of communication (longertek)
45 PFC module pre-alarm (longertek)
46 Pre-alarm for cooling over-temperature (APY)
47 Pre-alarm for overcurrent in acceleration (APY)
48 Pre-alarm for overcurrent at steady speed (APY)
49 Pre-alarm for overcurrent in deceleration (APY)
50 Pre-alarm for undervoltage on BUS DC (APY)
51 Pre-alarm for overvoltage on BUS DC (APY)
52 NOT USED
53 NOT USED
54 Pre-alarm for converter PFC fault (APY)
55 Pre-alarm for overcurrent in acceleration (APY)
56 Overload pre-alarm (APY)
57 Pre-alarm for overcurrent at steady speed (APY)
58 Pre-alarm for overcurrent in deceleration (APY)
59 Pre-alarm for incorrectly connected compressor (APY)
60 Pre-alarm for absence of communication (APY)
61 Pre-alarm for cooling fin temperature sensor error (APY)
62 NOT USED
63 NOT USED

Other manuals for AERMEC MODUCONTROL

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AERMEC MODUCONTROL and is the answer not in the manual?

AERMEC MODUCONTROL Specifications

General IconGeneral
BrandAERMEC
ModelMODUCONTROL
CategoryControl Unit
LanguageEnglish

Related product manuals