AERMEC MODUCONTROL Usage Manual

67
GB
6343841_00 / Ver - 4.20
ADDRESS DESCRIPTION
111 Alarm for IPM protection error (longertek)
112 Alarm for EEPROM error (longertek)
113 Alarm for compressor stalling (longertek)
114 Alarm for absence of communication (longertek)
115 PFC module alarm (longertek)
116 Alarm for cooling over-temperature (APY)
117 Alarm for overcurrent in acceleration (APY)
118 Alarm for overcurrent at steady speed (APY)
119 Alarm for overcurrent in deceleration (APY)
120 Alarm for undervoltage on BUS DC (APY)
121 Overvoltage alarm (APY)
122 NOT USED
123 NOT USED
124 Alarm for converter PFC fault (APY)
125 Alarm for overcurrent in acceleration (APY)
126 Overload alarm (APY)
127 Alarm for overcurrent at steady speed (APY)
128 Alarm for overcurrent in deceleration (APY)
129 Alarm for incorrectly connected compressor (APY)
130 Alarm for absence of communication (APY)
131 Alarm for cooling fin temperature sensor error (APY)
132 NOT USED
133 NOT USED
134 NOT USED
135 Fault condition alarm (APY)
136 NOT USED
137 NOT USED
138 Alarm for faulty reverse cycle valve
139 Alarm for high water inlet temperature
140 Alarm for reverse cycle due to high discharge gas temperature
141 (Code 57) Alarm remote reading of the probe within DHW
142 (Code 58) Alarm reading of temperature sensor outside air
143 NOT USED
144 NOT USED
145 NOT USED
146 NOT USED
147 NOT USED
148 NOT USED
149 NOT USED
150 NOT USED
151 NOT USED
152 NOT USED
153 NOT USED
154 NOT USED

AERMEC MODUCONTROL Specifications

General

Brand	AERMEC
Model	MODUCONTROL
Category	Control Unit
Language	English