GENERAL INFORMATION
1-17
GPIB (Option 5) For printing, remote instrument control or for programming of
user-defined test sequences.
Capability
Complies with the following subsets defined by IEEE488:
SH1, AH1, T6, L4, SR1, RL1, E1, DC1, DT0
SSB Demodulator (Option 8) The SSB demodulator allows signals to be demodulated
either via the intenal loudspeaker or via the accessory
socket. Provides demodulation of SSB signals (upper and
lower sideband.)
Modulation Meter
Frequency range 400 kHz to 1 GHz
AF demodulation range 10 Hz to 15 kHz
Distortion Typically less than 3% at 1 kHz (300 Hz to 3.4 kHz)
Detection range
2 µV to 150 W
Features Automatic detection of USB or LSB.
BFO can be used for tuning of carrier for AM and FM
radios.
CCITT Filter (Option 23) Allows a CCITT filter to be inserted into either the
demodulated audio path or the audio input path.
CMESS Filter (Option 24) Allows a CMESS filter to be inserted into either the
demodulated audio path or the audio input path.
Look and Listen (Option 27) Provides simultaneous spectrum display and demodulation
of the center frequency for span widths of 100 kHz, 200 kHz,
500 kHz and 1 MHz. Sensitivity 2 µV.
Bail arm and front panel stowage cover
(Option 30)
Provides a bail arm carrying handle and front panel cover
and storage area. The bail arm will also provide additional
viewing angles when mounted on a bench.
Internal Battery (Option 32)
Type 12 V Ni-mH
Normal capacity when new Typically 60 minutes instrument operation
Weight 1.8 kg (4 lb)
Charge time from instrument 4 hrs
Temperature range 5–35°C (41 to 95°F) charge; 0–50°C (32 to 122°F) discharge
Supplied Accessories
AC Supply lead †
43138/755 DC Supply lead
46882/744 Operating Manual
46882/683 Programming Manual
† The AC supply lead provided with the Service Monitor will
depend on the destination country. See Power
requirements, Power cords, in Chapter 2 of this manual
To Next Page
Loading...
