LOCAL OPERATION
3-10
Test mode screens and menus
The five test modes are selected by pressing the appropriate MODE key. These are light blue,
with dark blue lettering. (Item 16 in Fig. 3-1, Front panel). Select each in turn and observe the
display presented.
Each area of six soft key labels forms a menu. Various menus are called up as a result of selecting
a change of test mode or by pressing a soft key within a test mode.
There are fold-out diagrams at the end of this chapter that show the screens displayed when each
of the mode keys is pressed. These also show branching to the second or third level screens and
menus. A diagram of the screens accessed from the HELP/SETUP key is also included. These
fold out diagrams are numbered to correlate with the associated key position as follows:
(1.0) HELP/SETUP
(2.0) Tx TEST
(3.0) Rx TEST
(4.0) Dx TEST
(5.0) SPEC ANA
(6.0) AF TEST
References in the manual to specific screens on the fold out diagrams is given as in the following
example:
Fold out diagram (2-3-3). This is the screen shown after pressing the [Tx TEST] mode key, then
the [Mod Meter] key (third key down), followed by the [AF Filter] key (third key down). Where
there are keys on both sides of a screen, keys 1 to 6 are on the left, keys 7 to 12 on the right.
To move to the top level menu of any test mode, including the currently active mode, press the
relevant ‘MODE’ key.
For detailed use of specific TEST MODES see the section later in this chapter relating to that test
mode.
To Next Page
Loading...
