Chapter 10 Using HiveManager
108 Aerohive
This chapter explains how to do the following basic tasks:
• Use the console port to change the network settings for the MGT interface
• Power on HiveManager and connect it to a network
• Make an HTTPS connection from your management system to HiveManager and log in to the GUI
It then introduces the HiveManager GUI and includes a summary of the configuration workflow. Finally, the chapter
concludes with procedures for updating HiveManager software and HiveAP firmware. The sections are as follows:
• "Installing and Connecting to the HiveManager GUI" on page 109
• "Introduction to the HiveManager GUI" on page 113
• "Viewing Reports" on page 114
• "Searching" on page 115
• "Multiselecting" on page 116
• "Cloning Configurations" on page 116
• "Sorting Displayed Data" on page 117
• "HiveManager Configuration Workflow (Enterprise Mode)" on page 118
• "Updating Software on HiveManager" on page 119
• "Updating HiveOS Firmware" on page 120
• "Updating HiveAPs in a Mesh Environment" on page 121
To Next Page
Loading...
