Landing:
Allow sufficient battery to always return home safely, the aircraft can be landed
manually or automatically.
Manual Landing:
• Fly the aircraft overhead, then descend down into a safe landing area.
• Release any payload before landing the aircraft
• The aircraft is fitted with downward vision sensors, it will automatically
control its descent as it prepares to land.
• Continue to throttle down (descend) until the aircraft lands and the motors
automatically stop.
Note: Push both control sticks down and outwards (as shown on previous page)
to manually stop the motors if they do not automatically stop after landing.
Automatic Landing:
• Press the button on the app interface, or the button on the remote
to begin the RTH/Landing procedure.
• Ensure the RTH location is clear and safe to land in.
• The aircraft will fly overhead, then descend down directly. You can cancel
or manually adjust the automatic landing with the control sticks.
RTH Location:
• When pressing the button in the app, you can select to return to the
remote location, or land in the current location.
• The default RTH Location is the takeoff point, to change, tap and hold any
point on the map, then click ok, to set this as the new home point.
35
To Next Page