Provides a connection between the printer and the protective
earth of the mains. Do not remove this connection, because this
will have a negative influence on the leakage current.
Power button:
Note that the power cord has to be disconnected from the wall
outlet in order to disconnect the unit entirely from the mains.
Precautions for use in USA only:
Make sure that the circuit is single-phase center-tapped, if the
printer is connected to a 240 V/60 Hz source instead of a 120
V/60 Hz source.
Date of manufacture
Manufacturer
Medical device
Serial number
Unique device identifier, in text format and in machine readable
format
The most recent version of this document is available on http://
www.agfahealthcare.com/global/en/library/index.jsp
WEEE Symbol, see section about Environmental protection.
Device contains a transmitter module that generates non-ioniz-
ing radiation.
28 | Drystar 5500, Drystar 5503 | Introduction
2901J EN 20191018 0826
To Next Page
Loading...
