Agilent Technologies 33250A User Manual

256
Chapter 5 Error Messages
Execution Errors
5
-221 Settings conflict;
sweep turned off by selection of other mode or modulation
The function generator will allow only one modulation, sweep, or burst
mode to be enabled at the same time. When you enable a modulation,
sweep, or burst mode, all other modes are turned off.
-221 Settings conflict;
not able to modulate this function
The function generator cannot generate a modulated waveform using the
pulse, noise, or dc voltage functions.
-221 Settings conflict;
not able to sweep this function
The function generator cannot generate a sweep using the pulse, noise,
or dc voltage functions.
-221 Settings conflict;
not able to burst this function
The function generator cannot generate a burst using the dc voltage
function.
-221 Settings conflict;
not able to modulate noise, modulation turned off
The function generator cannot generate a modulated waveform using the
noise function. The selected modulation mode has been turned off.
-221 Settings conflict;
not able to sweep pulse, sweep turned off
The function generator cannot generate a sweep using the pulse
function. The sweep mode has been turned off.
-221 Settings conflict;
not able to modulate dc, modulation turned off
The function generator cannot generate a modulated waveform using the
dc voltage function. The selected modulation mode has been turned off.

Agilent Technologies 33250A Specifications

General

Brand	Agilent Technologies
Model	33250A
Category	Inverter
Language	English