Agilent Technologies 5977C Series User Manual

5977C GC/MSD Operating Manual 203
7 CI Maintenance
General Information 204
To Switch from the EI HES to the CI Source 205
To Remove the EI HES Radiator 206
To Connect/Disconnect Wiring to the EI HES Radiator 207
To Install the CI Source Radiator 209
To Switch from the CI Source to the EI HES 211
To Remove the CI Source Radiator 212
To Install the EI HES Radiator 214
To Switch from an EI XTR, SS, or Inert Source to the CI Source 215
To Switch from the CI Source to an EI XTR, SS, or Inert Source 216
To Remove the CI Source 217
To Connect/Disconnect non-HES Model Wiring from the CI Source 218
To Connect/Disconnect EI HES Model Wiring to the CI Source 219
To Disassemble the CI Source 220
To Clean the CI Source 223
To Assemble the CI Source 226
To Remove the CI Source Filament 229
To Install a CI Source Filament 231
To Install the CI Source 232
This chapter describes maintenance procedures and requirements that are unique
to 5977C Series MSDs equipped with the CI hardware.
If you are using the Agilent Intuvo 9000 Gas Chromatograph with your MSD,
Chemical Ionization (CI) is not currently supported.

Agilent Technologies 5977C Series Specifications

General

Brand	Agilent Technologies
Model	5977C Series
Category	Security Sensors
Language	English