Agilent 708-DS Dissolution Apparatus
Training Manual
Revision A September 2010
P/N: xx-xxxx
6. Method Setup and Execution with the 708-DS
6.1. 708-DS Method Setup (Stored)
This section discusses how to set up and store a dissolution method. A total of
five (5) dissolution methods may be stored in the memory of the instrument. To
begin, from the Main screen of the 708-DS, press Menu > Method Editor. The
Select Method screen displays. Press a number (1-5) corresponding to the
stored location of the Method. The first Method Properties screen displays.
Figure 6-1. Method Properties Screen 1
Press anywhere inside the Name box and create a title to describe the Method to
be created. Press Ok when finished.
Press anywhere inside the Duration box and enter the minimum time (in
HHH:MM:SS) for the Method. Press Ok when finished.
NOTE: The time entered as the test duration will be superseded by the sum
of the final time point and final spin if it is greater.
If vessel temperature probes are configured, press anywhere inside the Vessel
Temp box and enter the appropriate vessel temperature (in °C) for the Method.
Press Ok when finished.
Press anywhere inside the Bath Temp box and enter the appropriate bath
temperature (in °C) for the Method. Press Ok when finished.
Press anywhere inside the Spindle Speed box and enter an appropriate value
(in RPM) for the Method. Press Ok when finished.
Press anywhere inside the Media Volume box and enter an appropriate value (in
mL) for the Method. Press Ok when finished.
To Next Page
Loading...
Need help?
General
